Main Article Content
In this study, heat transfer and pressure drop characteristics have been experimentally investigated by using Al2O3/water nanofluids in the chevron-type plate heat exchanger. The purpose of the experiments was to determine the heat transfer coefficient and pressure drop for different flow rates of 90, 120, 150, 180, 240 and 300 kg/h and different volume concentrations of 0.25%, 0.5%, 0.75% and 1% of the nanofluids. The Nusselt number of the nanofluids increased with the increasing volume concentration and flow rate at constant hot water flow rate and constant inlet temperatures. The increase in the Nu number is 42.4% when compared to distilled water at the maximum volume concentration and Reynold number (600≤Re≤1900) in the nanofluids-plate heat exchanger. It has been concluded that nanofluids enhanced the heat transfer significantly and pressure drops at the maximum volume concentration and the Reynold number increased by between 6.4% and 8.4% compared to distilled water.
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
Authors retain copyright of the published article and have the right to use the article in the ways permitted to third parties under the - Creative Commons Attribution-NonCommercial-NoDerivs 4.0 International (CC BY-NC-ND) licence. Full bibliographic information (authors, article title, journal title, volume, issue, pages) about the original publication must be provided and a link must be made to the article's DOI.
The authors and third parties who wish use the article in a way not covered by the the -Creative Commons Attribution-NonCommercial-NoDerivs 4.0 International (CC BY-NC-ND) licence must obtain a written consent of the publisher. This license allows others to download the paper and share it with others as long as they credit the journal, but they cannot change it in any way or use it commercially.
Authors grant to the publisher the right to publish the article, to be cited as its original publisher in case of reuse, and to distribute it in all forms and media.
 Choi, S.U.S., Developments and Application of Non-Newtonian Flows, ASME FED-V.231/MD- V.66, New York, 1995. 99–105.
 Zhai, Y.L., Xia, G.D., Liu, X.F., Li, Y.F., Heat transfer enhancement of Al2O3-H2O nanofluids flowing through micro heat sink with complex structure, International Communications in Heat and Mass Transfer 66 (2015) 158 –166.
 Tuckerman, D.B., Pease, R.F.W., High-performance heat sinking for VLSI, IEEE Electr. Dev. Lett. EDL-2 (1981) 126–129.
 Daungthongsuk, W., Wongwises, S., A critical review of convective heat transfer of nanofluids, Renew. Sust. Energy Rev. 11 (2007) 797–817.
 Nandigana, V., Selvaraju, N., Mahadevan, K., Convective heat transfer coefficient of nanofluids. Lambert Academic Publishing, Germany, 2012.
 Heris, S. Z., Etemad, S.Gh., Esfahany, M. N., Experimental investigation of oxide nanofluids laminar flow convective heat transfer, International Communications in Heat and Mass Transfer 33 (2006) 529–535.
 Anoop, K.B., Sundararajan, T., Das, S. K., Effect of particle size on the convective heat transfer in nanofluid in the developing region, International Journal of Heat and Mass Transfer 52 (2009) 2189– 2195.
 Xu, L., Xu, J., Nanofluid stabilizes and enhances convective boiling heat transfer in a single microchannel, International Journal of Heat and Mass Transfer 55 (2012) 5673–5686.
 Edalati, Z., Heris, S. Z., Noie, S.H., The Study of Laminar Convective Heat Transfer of CuO/WaterNanofluid Through an Equilateral Triangular Duct at Constant Wall Heat Flux, Heat Transfer- Asian Research, 41 (5), 2012.
 Hojjat, M., Etemad, S. Gh., Bagheri, R., Thibault, J., Laminar convective heat transfer of non- Newtonian nanofluids with constant wall temperature, Heat Mass Transfer (2011) 47:203–209.
 Sommers, A. D., Yerkes, K. L., Experimental investigation into the convective heat transfer and system-level effects of Al2O3 -propanol nanofluid, J. Nanopart Res (2010) 12:1003–1014.
 Tiwari, A. K., Ghosh, P., Sarkar, J., Heat transfer and pressure drop characteristics of CeO2/water nanofluid in plate heat exchanger, Applied Thermal Engineering 57 (2013) 24-32.
 Huang, D., Wu, Z., Sunden, B., Pressure drop and convective heat transfer of Al2O3/water and MWCNT/water nanofluids in a chevron plate heat exchanger, International Journal of Heat and Mass Transfer, 89 (2015) 620–626.
 Heris, S. Z., Esfahany, M. N., Etemad, S.Gh., Experimental investigation of convective heat transfer of Al2O3/water nanofluid in circular tube, International Journal of Heat and Fluid Flow 28 (2007) 203–210.
 Mangrulkar, C.K., Kriplani, V. M., Dhoble, A. S., Experimental investigation of convective heat transfer enhancement using alumina/water and copper oxide/water nanofluids, Thermal science, 2015.
 Haddad, Z., Abid, C., Oztop, H.F., Mataoui, A., A review on how the researchers prepare their nanoﬂuids, International Journal of Thermal Sciences 76 (2014) 168-189.
 Ali, H. M., Azhar, M. D., Saleem, M., Saeed, Q. S., SAIEED, A., Heat transfer enhancement of car radiator using aqua based magnesium oxide nanofluids, Thermal science, 2015.
 Haddad, Z., Eiyad, A.N., Oztop, H.F., Mataoui, A., Natural convection in nanofluids: Are the thermophoresis and Brownian motion effects significant in nanofluid heat transfer enhancement, International Journal of Thermal Sciences 57 (2012) 152-162
 Pak, B.C., Cho. Y.I., Hydrodynamic and heat transfer study of dispersed flids with submicron metallic oxide particles, Experimental Heat Transfer 11, 1999, 151–170.
 Drew, D.A., Passman, S.L., Theory of Multi component Fluids. Springer, Berlin, 1999
 Ho, C.J., Liu, W.K., Chang, Y.S., Lin, C.C., Natural convection heat transfer of alumina-water nanoflid in vertical square enclosures: An experimental study, International Journal of Thermal Sciences 49, 2010, 1345–1353.
 Minkowycz, W. J., Sparrow, E. M., Abraham, J. P., Nanoparticle Heat transfer and fluid flow, CRC Press, Volume IV, Taylor & Francis Group, New York, 2013.
 Einstein, A., Investigations on the Theory of the Brownian Movement, Dover Publications, New York, 1956.
 Abdellahoum C., Mataoui A., Oztop H.F., Comparison of viscosity variation formulations for turbulent flow of Al2O3–water nanofluid over a heated cavity in a duct, Advanced Powder Technology 26 (2015) 1210–1218.
 Xuana, Y., Roetzel, W., Conceptions for heat transfer correlation of nanofluids, International Journal of Heat and Mass Transfer 43 (2000) 3701-3707.
 Sundar, L. S., Farooky, Md. H., Sarada, S. N., Singh, M.K., Experimental thermal conductivity of ethylene glycol and water mixture based low volume concentration of Al2O3 and CuO nanofluids, International Communications in Heat and Mass Transfer 41 (2013) 41–46.
 Yu W., Choi, S.U.S., The role of international layers in the enhanced thermal conductivity of nanofluids: A renovated Maxwell model, Int. J. Heat and Fluid Flow 28 (2007) 203–210.
 Tillman, P., Hill, J. M., Determination of nanolayer thickness for a nanofluid, International Communications in Heat and Mass Transfer 34 (2007) 399 – 407.
 Cengel, Y. A., Introduction to Thermodynamics and Heat Transfer, McGraw-Hill, Second Edition, 2007.
 Kakac, S., Liu, H., Heat Exchangers: Selection, Rating and Thermal Design, Third edition, CRC Press, USA, 2012.
 Shah, R. K., Sekulic, D. P., Fundamentals of heat exchanger design, John Wiley & Sons, Inc., USA, 2003.
 Holman, J.P., Experimental Methods for Engineers, Eighth edition, McGraw-Hill, New York, 2011.