Main Article Content
The paper reports experimental results using simulated condensation on eight horizontal integral finned tubes with different fin spacing but same root diameter. Condensation was simulated with low approaching zero vapor velocity of condensate using three liquids (water, ethylene glycol and R141b) supplied to the tube via small holes between the fins along the top of the tubes. Controlling parameters of the investigation were fin spacing of condensation tubes, flow rate of condensate and surface tension to density ratio of the condensate. The results indicate that the retention angle (measured from the top of the tube to the position where the inter-fin space is completely filled with liquid) increases with the increase in fin spacing. Also, retention angle increases as the density of the condensate increases but retention angle decreases with increase in surface tension. Interesting finding is seen as retention angle remains constant with increase in condensate flow rate, starting from very low (nearly zero) flow rate to the flow rate at which the tube gets fully flooded. The critical flow rate for eight tubes of defined fin density against three working fluids is measured. Results obtained from simulated condensation for almost zero condensate velocity are in good agreement with earlier data and theoretical model for retention angle on such tubes .
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
Authors retain copyright of the published article and have the right to use the article in the ways permitted to third parties under the - Creative Commons Attribution-NonCommercial-NoDerivs 4.0 International (CC BY-NC-ND) licence. Full bibliographic information (authors, article title, journal title, volume, issue, pages) about the original publication must be provided and a link must be made to the article's DOI.
The authors and third parties who wish use the article in a way not covered by the the -Creative Commons Attribution-NonCommercial-NoDerivs 4.0 International (CC BY-NC-ND) licence must obtain a written consent of the publisher. This license allows others to download the paper and share it with others as long as they credit the journal, but they cannot change it in any way or use it commercially.
Authors grant to the publisher the right to publish the article, to be cited as its original publisher in case of reuse, and to distribute it in all forms and media.
 Briggs, A., Forced-Convection Condensation on Horizontal Finned Tubes, Ph. D. thesis, University of London, UK, 1991
 Wen, A., Rose, J. W., Briggs, A., Accurate Heat Transfer Measurements for Condensation on Horizontal, Integral-Fin Tubes, Trans. ASME J. Heat Transf, 114 (1992), pp. 719 - 726
 Briggs, A., Namasivayam, S., Effect of Vapour Velocity on Condensation of Atmospheric Pressure Steam on Integral-Fin Tubes, Applied Thermal Engineering, 52 (2004) pp. 1353-1364
 Owen, W. C., Sardesai, R. G., Smith, R. A., Gravity controlled Condensation on Low Integral- Fin Tubes in Condenser: Theory and Practice, Theory and Practice.: I Chem. E. Symposium Serial No. 75, 415-428.1983
 Rudy, R. L., and Webb, T. M., Theoretical Model for Condensation on Horizontal Integral-Fin Tubes, American Institute of Chem. Engineering Symposium Serial Number 79, 1983
 Briggs, A., Liquid Retention on Three-Dimensional Pin-Fin Tubes, Proceedings, 2nd Int. Exergy and Environment Symposium, 2005, Paper no. IEEES2-171.
 Fitzgerald, C. L., Forced-Convection Condensation Heat-Transfer on Horizontal Integral-Fin Tubes Including Effects of Liquid Retention, Ph.D. Thesis, University of London, UK, 2011
 Namasivayam, S., Briggs, A., Condensate of ethylene glycol on integral-fin tubes - effect of fin geometry and vapor velocity, Trans. ASME Journal of Heat Transfer, (2005) pp. 1197 - 1206
 Briggs, A., Theoretical and experimental studies in shell-side condensation, Thermodynamics, Proccedings. Keynote paper, 6th Int. Conf. on Heat Transfer, Fluid Mechanics, Pretoria, South Africa, 2008
 Bella, A., Cavallini, A., Longo, G. A. Rosseto, L., Pure vapor condensation refrigrants 11 and 113 on a horizontal integral fin tube at high vapor velocity, Enhanced Heat Transfer, 1 (1993) , pp. 77 - 86
 Cavallini, A., Dorreti, L., Longo, G. A., Rosseto, L., Experimental investigation of condensate flow patterns on Enhanced surfaces, Proceedings, CFC, The day after, IIR International Conference, Padua, Italy, 1994
 Wang, H. S., Rose, J. W., Theoretical Investigation on Condensation on low-finned tubes, Proccedings, Heat SET , Chambery, France, 2007
 Fitzgerald, C. L., Briggs, A., Rose, J. W., Wang, H. S., Effect of vapour velocity on condensate retention between fins during condensation on low-finned tubes, International Journal of Heat and Mass Transfer, 1 (2012) 55, pp. 1412–1418
 Ali, H. M. and Briggs, A., Condensation of R-113 on Pin-Fin Tubes: Effect of Circumferential Pin Thickness and Spacing, Heat Transfer Engineering, 33 (2012), pp. 205-212.
 Ali, H. M. and Briggs, A., Condensation Heat Transfer on Pin-Fin Tubes: Effect of Thermal Conductivity and Pin Height, Applied Thermal Engineering, 60 (2013), pp. 465-471.
 Ali, H. M. and Briggs, A., Enhanced Condensation of ethylene glycol on Pin-Fin Tubes: Effect of Pin Geometry, ASME J. of Heat Transfer, 134 (2012), 011503.
 Ali, H. M. and Briggs, A., An investigation of Condensate Retention on Pin-Fin Tubes, Applied Thermal Engineering, 63 (2014), pp. 503-510.
 Ali, H. M. and Briggs, A., Condensation of ethylene glycol on Pin-Fin Tubes: Effect of Circumferential Pin Thickness and Spacing, Applied Thermal Engineering, 49 (2012), pp. 9-13.
 Ali, H.M and Briggs, A., A Semi-Empirical Model for Free-Convection Condensation on Horizontal Pin-Fin Tubes, Int. J. of Heat and Mass Transfer, 81(2015), pp. 157-166.
 Ali, H.M and Abubaker, M., Effect of Vapour Velocity on Condensate Retention on Horizontal Pin-Fin Tubes, Energy Conversion and Management, 86 (2014), pp. 1001-1009.
 Ali, H.M and Ali, A., Measurements and Semi-Empirical Correlation for Condensate Retention on Horizontal Integral-Fin Tubes: Effect of Vapour Velocity, Applied Thermal Engineering, 71 (2014), pp. 24-33.
 Ali, H.M and Abubaker, M., Effect of Circumferential Pin Thickness on Condensate Retention as a Function of Vapor Velocity on Horizontal Pin-Fin Tubes, Applied Thermal Engineering, 91(2015), pp. 245-251.