# SIMULATION OF NATURAL CONVECTION OF NANOFLUIDS IN A SQUARE ENCLOSURE EMBEDDED WITH BOTTOM DISCRETE HEATER

## Main Article Content

## Abstract

The present work aims at studying natural convection of nanofluids in a square enclosure embedded with a discrete heater at the bottom. The numerical simulations are performed using commercial software ‘STAR CMM+’ based on finite volume technique. Firstly, the results from the simulations are validated against the published results. Subsequently, numerical simulations have been carried out for predicting the flow and heat transfer characteristics of different water based nanofluids (Al_{2}O_{3}, Cu, TiO_{2}) at wide range of Rayleigh numbers, volume fractions, position of the heater and heater length. Results are presented in the form of streamline plots, isotherm contours and plots of average Nusselt numbers. It has been found that the average Nusselt number increases with increasing Rayleigh number, volume fraction and heater length. Further, the effect of heater position on the flow and temperature fields for different nanofluids are discussed. However, Nusselt number was observed to be sensitive to the position of the heater.

## Article Details

**Thermal Science**, [S.l.], mar. 2017. ISSN 2334-7163. Available at: <http://thermal-science.tech/journal/index.php/thsci/article/view/2325>. Date accessed: 24 feb. 2018. doi: https://doi.org/10.2298/TSCI160413314M.

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Authors retain copyright of the published article and have the right to use the article in the ways permitted to third parties under the - Creative Commons Attribution-NonCommercial-NoDerivs 4.0 International (CC BY-NC-ND) licence. Full bibliographic information (authors, article title, journal title, volume, issue, pages) about the original publication must be provided and a link must be made to the article's DOI.

The authors and third parties who wish use the article in a way not covered by the the -Creative Commons Attribution-NonCommercial-NoDerivs 4.0 International (CC BY-NC-ND) licence must obtain a written consent of the publisher. This license allows others to download the paper and share it with others as long as they credit the journal, but they cannot change it in any way or use it commercially.

Authors grant to the publisher the right to publish the article, to be cited as its original publisher in case of reuse, and to distribute it in all forms and media.

Accepted 2017-03-14

Published 2017-03-14

## References

[2] Khanafer, K., Vafai, K., and Lightstone, M., Buoyancy-driven heat transfer enhancement in a two- dimensional enclosure utilizing nanofluids, Int. J. Heat Mass Transf., 46 (2003), 19, pp. 3639–3653.

[3] Jou, R.-Y., and Tzeng, S.-C., Numerical research of nature convective heat transfer enhancement filled with nanofluids in rectangular enclosures, Int. Commun. Heat Mass Transf., 33 (2006), 6, pp. 727–736.

[4] Abu-Nada, E., Masoud, Z., Oztop, H. F., and Campo, A., Effect of nanofluid variable properties on natural convection in enclosures, Int. J. Therm. Sci., 49 (2010), 3, pp. 479–491.

[5] Tiwari, R. K., and Das, M. K., Heat transfer augmentation in a two-sided lid-driven differentially heated square cavity utilizing nanofluids, Int. J. Heat Mass Transf., 50 (2007), 9–10, pp. 2002–2018.

[6] Jang, S. P., Lee, J.-H., Hwang, K. S., and Choi, S. U. S., Particle concentration and tube size dependence of viscosities of Al2O3-water nanofluids flowing through micro- and minitubes, Appl. Phys. Lett., 91 (2007), 24, pp. 243112.

[7] Lai, F.-H., and Yang, Y.-T., Lattice Boltzmann simulation of natural convection heat transfer of Al2O3/water nanofluids in a square enclosure, Int. J. Therm. Sci., 50 (2011), 10, pp. 1930–1941.

[8] Parvin, S., Nasrin, R., Alim, M. a., and Hossain, N. f., Double-diffusive natural convection in a partially heated enclosure using a nanofluid, Heat Transfer—Asian Res., 41 (2012), 6, pp. 484–497.

[9] Rashmi, W., Ismail, A. F., Khalid, M., and Faridah, Y., CFD studies on natural convection heat transfer of Al2O3-water nanofluids, Heat Mass Transf., 47 (2011), 10, pp. 1301–1310.

[10] Santra, A. K., Sen, S., and Chakraborty, N., Study of heat transfer augmentation in a differentially heated square cavity using copper–water nanofluid, Int. J. Therm. Sci., 47 (2008), 9, pp. 1113–1122.

[11] Wang, X. Q., Mujumdar, A. S., and Yap, C., Free convection heat transfer in horizontal and vertical rectangular cavities filled with nanofluids, Begell House Inc., Proceedings, International Heat Transfer Conference IHTC-13., Sydney, Australia (2006).

[12] Chao, P. K.-B., Ozoe, H., Churchill, S. W., and Lior, N., Laminar Natural Convection in an Inclined Rectangular Box With the Lower Surface Half-Heated and Half-Insulated, J. Heat Transf., 105 (1983), 3, pp. 425–432.

[13] Orhan Aydin, and Wen‐Jei Yang, Natural convection in enclosures with localized heating from below and symmetrical cooling from sides, Int. J. Numer. Methods Heat Fluid Flow, 10 (2000), 5, pp. 518–529.

[14] Ishihara, I., Fukui, T., and Matsumoto, R., Natural convection in a vertical rectangular enclosure with symmetrically localized heating and cooling zones, Int. J. Heat Fluid Flow, 23 (2002), 3, pp. 366–372.

[15] Ahmet Koca, H. F. O., The effects of Prandtl number on natural convection in triangular enclosures with localized heating from below, Int. Commun. Heat Mass Transf., 34 (2007), 4, pp. 511–519.

[16] Manab Kumar Das, and Pravin Shridhar Ohal, Natural convection heat transfer augmentation in a partially heated and partially cooled square cavity utilizing nanofluids, Int. J. Numer. Methods Heat Fluid Flow, 19 (2009), 3/4, pp. 411–431.

[17] Oztop, H. F., and Abu-Nada, E., Numerical study of natural convection in partially heated rectangular enclosures filled with nanofluids, Int. J. Heat Fluid Flow, 29 (2008), 5, pp. 1326–1336.

[18] Ternik, P., Conduction and convection heat transfer characteristics of water–Au nanofluid in a cubic enclosure with differentially heated side walls, Int. J. Heat Mass Transf., 80 (2015), pp. 368–375.

[19] Ternik, P., and Rudolf, R., Numerical Analysis of Continuous Casting of NiTi Shape Memory Alloy, Int. J. Simul. Model., 15 (2016), 3, pp. 522–531.

[20] Ternik, P., Rudolf, R., and Žunič, Z., Numerical study of heat-transfer enhancement of homogeneous water-Au nanofluid under natural convection, Mater. Tehnol., 46 (2012), 3, pp. 257– 261.

[21] Primož Ternik and Rebeka Rudolf, Conduction and convection heat transfer characteristics of water- based Au nanofluids in a square cavity with differentially heated side walls subjected to constant temperatures, Thermal Science, 18 (2014), 1, pp. S189-S200.

[22] Maïga, S. E. B., Palm, S. J., Nguyen, C. T., Roy, G., and Galanis, N., Heat transfer enhancement by using nanofluids in forced convection flows, Int. J. Heat Fluid Flow, 26 (2005), 4, pp. 530–546.

[23] Palm, S. J., Roy, G., and Nguyen, C. T., Heat transfer enhancement with the use of nanofluids in radial flow cooling systems considering temperature-dependent properties, Appl. Therm. Eng., 26 (2006), 17–18, pp. 2209–2218.

[24] Ternik P and Rudolf R., Heat Transfer Enhancement for Natural Convection Flow of Water Based Nano Fluids in a Square Enclosure., Int j simul model., 11(2012) 1, 29-39.