Regular issue: 34 original scientific and Open Forum papers.

Published: 2016-02-16

NEW METHODS TO PROVIDE EXACT SOLUTIONS FOR SOME UNIDIRECTIONAL MOTIONS OF RATE TYPE FLUIDS

Corina FETECAU, Qammar RUBBAB, Shahraz AKHTER, Constantin FETECAU

7-20

MIXED CONVECTION BOUNDARY-LAYER FLOW OF A MICRO POLAR FLUID TOWARDS A HEATED SHRINKING SHEET BY HOMOTOPY ANALYSIS METHOD

Mohammad Mehdi RASHIDI, Muhammad ASHRAF, Behnam ROSTAMI, Mohammad Taher RASTEGARI, Sumra BASHIR

21-34

NEW METHODS TO COPE WITH TEMPERATURE ELEVATIONS IN HEATED SEGMENTS OF FLAT PLATES COOLED BY BOUNDARY LAYER FLOW

Mohammad R. HAJMOHAMMADI, Mohammad MOULOD, Omid JONEYDI SHARIATZADEH, Seyed Salman NOURAZAR

45-52

HEAT TRANSFER ENHANCEMENT WITH ELLIPTICAL TUBE UNDER TURBULENT FLOW TiO2-WATER NANOFLUID

Adnan M. HUSSEIN, Rosli Abu BAKAR, Kumaran KADIRGAMA, Karada Viswanatha SHARMA

89-97

OPTIMIZATION OF NANOFLUID-COOLED MICROCHANNEL HEAT SINK

Ahmed Mohammed ADHAM, Normah Mohd-GHAZALI, Robiah AHMAD

109-118

RAYLEIGH TAYLOR INSTABILITY IN DUSTY MAGNETIZED FLUIDS WITH SURFACE TENSION FLOWING THROUGH POROUS MEDIUM

Ram P. PRAJAPATI, Praveen K. SHARMA, Anita TIWARI, Rajendra K. CHHAJLANI

119-130

HEAT TRANSFER MODELLING OF TWO-PHASE BUBBLES SWARM CONDENSING IN THREE-PHASE DIRECT-CONTACT CONDENSER

Hameed B. MAHOOD, Adel. O. SHARIF, Sami Al-AILBI, Sayid Ali HOSSINI, Rex B. THORPE

143-153

OUTDOOR TESTING OF PHOTOVOLTAIC MODULES DURING SUMMER IN TAXILA, PAKISTAN

Hafiz Muhammad ALI, Mubashar MAHMOOD, Muhammad Anser BASHIR, Muzaffar ALI, Aysha Maryam SIDDIQUI

165-173

PERFORMANCES OF PACKED BED DOUBLE PASS SOLAR AIR HEATER WITH DIFFERENT INCLINATIONS AND TRANSVERSE WIRE MESH WITH DIFFERENT INTERVALS

Sam Stanley SUGANTHARAJ GNANADURAI, Anbarasan VIJAY KUMAR, Kalidasa Murugavel KULUNDAIVEL

175-183

TEMPERATURE STRATIFICATION IN A ROAD TUNNEL

Brahim KALECH, Zouhaier MEHREZ, Mourad BOUTERRA, Afif El CAFSI, Ali BELGHITH

223-237

THE INFLUENCE OF ELECTRIC ARC ACTIVATION ON THE SPEED OF HEATING AND THE STRUCTURE OF METAL IN WELDS

Darko R. BAJIĆ, Oleksandr M. SAVYTSKY, Mychailo M. SAVYTSKY, Yuriy M. SHKRABALYUK, Tomaz VUHERER

239-246

ANALYSIS OF THE TOOL PLUNGE IN FRICTION STIR WELDING

Darko M. VELJIĆ, Bojan L. MEDJO, Marko P. RAKIN, Zoran M. RADOSAVLJEVIĆ, Nikola S. BAJIĆ

247-254

PERFORMANCE ANALYSIS OF A RE-CIRCULATING HEAT PUMP DRYER

Salih COSKUN, Nurettin YAMANKARADENIZ, K. Furkan SOKMEN, Omer KAYNAKLI, Bilsay PASTAKKAYA

267-277

THE EFFECT OF FUEL PYROLYSIS ON THE COAL PARTICLE COMBUSTION – AN ANALYTICAL INVESTIGATION

Alireza RAHBARI, Mostafa BAGHSHEIKHI, Seyed Mehdi ASHRAFIZADEH, Mehdi BIDABADI

279-289

PERFORMANCE IMPROVEMENT OF A 330 MWe POWER PLANT BY FLUE GAS HEAT RECOVERY SYSTEM

Wenguo XIANG, Changchun XU, Min XU, Ming ZHAO, Junyu LIANG, Juncong SAI, Yalin QIU

303-314

ENERGY AND EXERGY EFFICIENCY OF HEAT PIPE EVACUATED TUBE SOLAR COLLECTORS

Farzad JAFARKAZEMI, Emad AHMADIFARD, Hossein ABDI

327-335

DEVELOPMENT OF A SIMPLIFIED MODEL FOR DROPLET VAPORIZATION

Mingrui WEI, Helin XIAO, Liangrui ZHAO, Zhongzhao LI, Guanlun GUO

337-345